Product Description
Mark VI Simplex DIN-rail Mounted Thermocouple Terminal Board IS210DTTCH1AA must be used with the VTCC Thermocouple Processor Board. The connector used to connect the two boards together is a thirty-seven-pin cable connector located on the upper portion of the board near the DTTC board identification. Please note that this cable connector is identical to the connector that is on the larger TBTC board. The board can be mounted in such a way as to conserve cabinet space if there is more than one board being inserted into the cabinet, the best way to conserve cabinet space is to stack the boards vertically.
When the DTTC model is being used with other temperature monitoring functions it can be used with the TBTC/TRTD terminal barrier boards and the DTAI termination box board. It should be noted that the model is more likely to be used with the DTAI termination box board due to the fact that the temperature monitoring function requires two box-type termination boards. When using this board in a backup protection module it is possible that up to nine more thermocouple inputs can be monitored.
All of the above information has been compiled from two different manuals produced by General Electric. Most of the information regarding the IS210DTTCH1AA board was taken from the GEH-6421C Volume II System Guide for the Speedtronic Mark VI Turbine Control Series. The information in the GEH-6421C manual is found on pages 9-34 and 9-35. Another manual that can be used is the GER-4193A Speedtronic Mark VI Turbine Control System Manual which has information in table three on page four. Both of these manuals can be found above under the manuals tab on this page.