IS210DTCIH1A

About the IS210DTCIH1A

As a Simplex Contact Input with Group Isolation terminal board, the IS210DTCIH1A is a small board that connects via one cable to either a VCCC or VCRC board. Only a simplex version is available of the DTCI board. It mounts via DIN-rails, using the plastic holder that surrounds the edges of the board and its attached clips.  This IS210DTCIH1A product is actually not the originally-developed device of its specific Mark VI Turbine Control System Series functionality, as that would have to be considered the IS210DTCIH1A parent Simplex Contact Input Terminal Board notably not making use of this IS210DTCIH1A device's unique revision history. The board has:

• a 37-pin female cable connector
  • with latching fasteners
• a 60-terminal Euroblock terminal strip
  • permanently mounted to the board surface
• no PDIA Input/Output pack compatibility

 IS210DTCIH1A Simplex Contact Board Voltages

The IS210DTCIH1A has no configurable hardware located on its surface. The board is populated by resistors, capacitors, and diodes. Excitation voltage on this board is scaled for 24 VDC and will trip a diagnostic alarm if it falls below 50% of that 24 V dc nominal voltage. The board uses hardware filters to reduce high frequency noise. Please refer to manufacturer publications for installation procedures. This IS210DTCIH1A PCB product is not followed online by any large amount of originally-developed instructional manual documentation, at least any documentation pertinent to this IS210DTCIH1A personalized product page here, most likely due to its greater Mark VI product series' status as a highly copyright infringed-upon GE Mark product series.