About the IS200EXAMG1BAA
The IS200EXAMG1BAA is used as an Exciter Attenuator Module. This module works together with the EGDM board as a field ground detector to protect the system’s generator shaft. Together, these two boards can detect any ground paths from exciter components that may be present. The IS200EXAMG1BAA acts to drive the electrical center of the field winding with a low-frequency ac voltage relative to ground. The IS200EXAMG1BAA is built with two female connectors, including one female 3-position plug (J1) and a female nine-position cable connector (J2) that is also labeled “Ground Detector.” The circuit card has one screw connection for the use of surface wiring (TB1,) three jumper switches, and two stab-on connectors. The stab-on connectors are labeled E1 (Vbus-p) and E2 (Vbus-n.) It also has two metal oxide varistors, one relay, four large capacitors made from polyester vinyl, twenty wire-wound resistors as well as resistors of other material. The board ID number and manufacturer’s logo are both present on the board’s surface.
IS200EXAMG1BAA Hardware in Number Form
The IS200EXAMG1BAA Exciter Attenuation Module's IS200EXAMG1BAA functional product number itself can too be defined as a decent supplementary source of IS200EXAMG1BAA Board hardware component and component specification information, as it codes for a series of relevant IS200EXAMG1BAA Board details through a set of consecutive functional naming chunks. For instance, the IS200EXAMG1BAA product number is started off through an instance of the dual-functional IS200 series tag indirectly asserting this IS200EXAMG1BAA device's normal Mark VI Series assembly type as well as its domestic original manufacture location. Some of the other relevant IS200EXAMG1BAA details revealed in this manner include its:
- EXAM functional product abbreviation
- Normal PCB coating style
- Group one Mark VI Series grouping
- Three-fold revision table