About the IS200EISBH1AAC
The IS200EISBH1AAC is built with a front faceplate that includes two set pins that lock the board into place once it has been installed in the rack system. These are marked with the board id number and with the General Electric logo. In between these, the board has an opening to access a reset switch (actually located on the board’s surface) and several fiber-optic connectors. The fiber optic connectors are labeled Gen Field voltage and current, Exciter voltage and current, and Ground Detect In and Out. The faceplate connects to the circuit board using screws. The circuit board is marked with several codes and barcodes. It is factory-drilled along its edge in several locations. The board is also marked with the GE logo. Components are marked with reference designators. The board has over twenty integrated circuits. It has inductor coils, resistors, capacitors, several transistors, and diodes, as well as the aforementioned reset switch. The board also has two small transformers and a single backplane connector that is used for both inputs and outputs of fiber-optic feedback signals.
IS200EISBH1AAC Exciter ISBus Board functional product number itself in this instance gains a new light as a fine original source of IS200EISBH1AAC Exciter ISBus Board hardware component and component specification information, as it codes for a number of relevant IS200EISBH1AAC Exciter ISBus Board details through a series of consecutive functional naming chunks. For starters, this IS200EISBH1AAC Exciter ISBus Board product number in specific is kicked off through the inclusion of the dual-functional IS200 series chunk delegating both this IS200EISBH1AAC Exciter ISBus Board product's normal Mark VI Series assembly as well as its domestic original GE manufacture location. Some of the other IS200EISBH1AAC Exciter ISBus Board details indicated in this manner include its:
- EISB functional product acronym
- Conformal PCB Coating
- Group one Mark VI Series grouping
- Three-fold revision table
