The IC620CBL001 unit is the HHP/PLC cable for the Micro PLC series by GE Fanuc. This cable can typically be seen within AX Control’s stock, so be sure to check on our website or give us a call to check on its availability.
The IC620CBL001 HHP/PLC cable is used to connect the HHP, the EPROM programmer, or a computer to your chosen Micro PLC system. This cable includes a 9/25 pin adapter with it.
The IC620CBL001 HHP/PLC cable can be used for a variety of different tasks. For example, the IC620CBL001 HHP/PLC cable is a necessary component for using the handheld programmer, which has the model number IC620ACC001, in both online and monitoring mode. The cable connects to the top of the programmer and to the bottom right of the Micro PLC unit. This is also a necessary process for transferring a program between the handheld programmer and the Micro PLC unit. In addition to that, this process is done if you want to use the operator interface unit, which has the model number IC620ACC003, in online mode as well.
When using the IC620CBL001 HHP/PLC cable to connect a computer to your Micro PLC unit, be sure to take extra precautions. The Micro PLC and the computer must be connected to the exact same ground point. In the event that these two devices are not connected to the same ground point, then damage to both of them can occur. However, if your Micro PLC unit is AC powered, you must connect it to the same power source as the computer.
AX Control Inc. sells new surplus and reconditioned products. This website is not sanctioned or approved by any manufacturer or tradename listed.
AX Control Inc. is not an authorized distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands appearing
herein are the property of their respective owners.
Copyright 2020 - AX Control Inc. - All Rights Reserved