The 531X302DCIAHG2 is a DC Instrumentation Card created by General Electric. The 531X302DCIAHG2 has three glass fuses tucked into the top right corner. The fuses are a safety device that will “POP” or break if the electrical current is too high. This prevents the rest of the circuit board from being damaged. The 531X302DCIAHG2 has four black metal support cages for the larger components on the circuit board to be secured to. The 531X302DCIAHG2 has multiple red light emitting diodes placed around the circuit board. The 531X302DCIAHG2 has a lot of small pins called jumper pins placed around the circuit board. The jumper pins use small caps to manually be turned on and off. The 531X302DCIAHG2 has several transistors. The transistors purpose is to amplify electrical signals. The 531X302DCIAHG2 has a single transformer. The 531X302DCIAHG2 has multiple resistors in order to dispel energy that is no longer needed. If the 531X302DCIAHG2 does need back up energy it can pull it from the many capacitors that have it stored. In order to decide what to do and when to do it the 531X302DCIAHG2 relays on the information stored in the multiple integrated circuits. The bottom right hand side of the circuit board it pretty open to adding additional parts if needed. The area the parts should be placed is outlined and labeled in order to see what type of part needs to go in each area. Please refer to General Electric’s manuals and data sheets for proper procedures.
Email or call AX Control to order yours today.