FN-PC10SK41

About the FN-PC10SK41

The FN-PC10SK41 is a flex network single-axis positioning unit, manufactured by Pro-face - Digital Electronics and it controls a servo motor and stepping motor. It is a digital electronic (now Schneider Electric) human-machine Interface that allows users to connect stepping motors or servo motors to Pro-face GLC's and It handles up to 2MHz. The dimensions are W 122 x H 196 x D 35mm [4.80 x 7.72 x 1.38in.]. The FN-PC10SK41 has an allowable voltage drop of up to 10ms and the input voltage is DC24V. The power consumption rate is 4.5W or less, and the standards is set at a protection level equivalent to IP30. The FN-PC10SK41 weighs approximately 700g (Main unit only). The required ambient operating temperature is 0° to 55°C.

For the control input, the rated voltage is DC24V and the rated voltage range is DC20.4V to DC28.8V. The maximum allowable voltage input is DC26.4V. It has 5 input points and input ON voltage of DC19V or higher, the input OFF voltage being 5V or less. The input impedance is 3.9kΩ. The input delay (off-on and on-off) is 1.5m or less. The storage temperature is -25° to +70°C and the ambient humidity is 30%RH to 95%RH (no condensation). It is free of corrosive gases and requires an atmospheric pressure of 800hPa to 1114hPa (2000 meters or lower).

The FN-PC10SK41 has been discontinued by Pro-face, but AX Control continues to buy, sell, and repair these models.