Product Description
The GE TC2000 Trip Board DS200TCTEG1A is populated with 20 plug-in relays. It also has 3 50-pin connectors and 2 12-pin connectors. The IDs assigned to the 50-pin connectors are JLY, JLX and JLZ. The IDs assigned to the 12-pin connectors are JN and JM. The GE TC2000 Trip Board DS200TCTEG1A isn’t populated with indicator LEDs or other means of indicating the health of the drive with a glance. If you suspect that a relay is not working it is easy to remove one relay and replace it with another.
The relays are held in place with a wire retention latch. To remove it, unclip the latch from the bottom of the connector and swing the wire latch over the top of the relay. Then use one finger to remove the wire latch from the bottom of the connector. Put the wire latch to one side. Pull up on the relay to remove it from the connector. The relay can be discarded. To install the new relay, press it into the empty connector on the board. It will click into place in the socket. Clip one end of the retention wire on the bottom of the connector. Then, swing it over the relay and clip it on the other side of the connector. You can pull on the retention wire to verify that it is secure.
When you remove the board from the drive, care must be taken that the relays do not strike objects in the interior of the drive and damage them. Have an unobstructed view of the drive interior so you can clearly see if the relays are near other objects.