About the DS200SVIAG1ABB
Hardware Tips and Specifications
The DS200SVIAG1ABB Shunt Isolator card is a rectangular board with:
- two terminal blocks located on either short board edge
- these terminal blocks can connect a maximum of fifteen signal wires to the board
- each terminal is numbered so you can easily match and reconnect signal wires to the correct terminals when rewiring a replacement DS200SVIAG1ABB board
- an LED indicator
- two jumper switches (labeled JP1 and JP2)
- several TP test points
- Jumpers used for board configuration
- two functional revision
- a singular board artwork configuration revision
- the General Electric grades that these significant revisions received sit at A, B, and B, respectively.
Additionally, the board includes resistors, capacitors, three potentiometers, a relay, and an AD210AN isolation amplifier chip. Most of these listed hardware components have been attached to the assembly of this DS200SVIAG1ABB PCB for voltage-storing and voltage-limiting purposes.
The board is marked with several codes and is drilled at each corner to allow for mounting on a carrier device like the 336A3484C2; these factory-drilled installation holes have been insulated in recognition of this DS200SVIAG1ABB Shunt Isolator Board's static-sensitive product status.