Product Description
The DS200SLCCG1AHH is a Mark V board component. It is a replacement LAN Communications Module with a 16-digit alphanumeric display mounted to its surface. This LAN communication module is one of many different SLCC modules available within AX Control inventory, so it is important that you are familiar with the exact unit needed for your particular application. We recommend ordering a replacement that exactly matches your current part number. However, please note that DS200 level boards typically do not come with software EPROMs (U6 and U7) installed. In most typical installations you will remove these EPROMs from your old board and install them on your newly ordered board once it arrives. However, if you need a board with the U6 and U7 EPROMs already installed, please order a similarly named DS215 board instead.
The DS200SLCCG1AHH module mounts upon the SDCC module within the Mark V system. These two modules interface together through a ribbon connector attached to the KPPL connector located on the SLCC board. After it has been mounted into place, the SDCC cover snaps over the SLCC module in such a way as to leave the 16-digit alphanumeric display visible. There are four pin-like structures at the end of this display that protects the glass covering from too much pressure. While there are several jumpers on the board, these pins do not function as such. Meanwhile, jumper settings for both the berg-type and wire jumpers can be found within associated user guides and manuals. Other board components include resistors, diodes, resistor network arrays, and capacitors.