DS200GSIAG1CGD

Product Description

The GE Common DC Bus Regenerative Board DS200GSIAG1CGD contains three 40-pin connectors, two 16-pin connectors, and 6 jumpers. The board also has 1 8-pin connector, and multiple test points. The GE Common DC Bus Regenerative Board DS200GSIAG1CGD also is populated with one LED that is located on one edge of the board. It is visible from the side of the board when the board is installed in the board rack. It is red in color when lit and it indicates when processing activity is occurring on the board. The LED will flash while activity is taking place.

The board rack is a structure in the drive in which multiple boards can be installed. The boards are secured with screws in the rack. When you replace a board, use a screwdriver to loosen or tighten the screws. However, the screwdriver can damage the components or other boards if you allow it to scrape against the components, jab the components, or otherwise cause damage. To prevent that from happening, have a clear view of the interior of the cabinet so you can direct where the screwdriver is touching. Also, hold the board by the edges and use two hands. This helps prevent damage to components which would happen if you press down on the components and bend wire pins or break off components.

Also, make sure to remove the board and keep it away from the edges of the cabinet to prevent damage to the board. Place the board on a level surface.