About the DS200GSIAG1CDC
The DS200GSIAG1CDC functions as a GE Common DC bus Regenerative Card. It is used as part of GE’s Mark V turbine control system, used to monitor and control industrial gas and steam turbines.
This particular DS200GSIAG1CDC Common DC Bus Regenerative Card is not the originally-manufactured product of its specific functionality to feature in the Mark V Turbine Control System Series; that would be the DS200GSIAG1 Common Bus Regenerative Board, which is missing all three of this DS200GSIAG1CDC product's functional or artwork revisions.
Hardware Tips and Specifications
As with any product offering available in our inventory of new and used General Electric printed circuit boards, this DS200GSIAG1CDC PCB's functionality is introduced alongside the adoption of several critical hardware components. The DS200GSIAG1CDC has several vertical pin connectors along its top edge. Along with these are cable connectors. The board has a Xilinx FPGA or Field Programmable Gate Array located near its center along with many other integrated circuits. Two toroidal transformers are close to one short edge. Other board components include:
- TP test points
- resistors
- resistor network arrays
- capacitors
- transistors
- jumper switches
- diodes
Most of these components were included in its normal style of Mark V Series assembly for voltage-protection reasons. This DS200GSIAG1CDC PCB's robust mounting strategy is supported by its base circuit board's permeation in several locations by numerous factory-drilled installation holes. Each of these installation-minded factory-drilled holes has been ringed with an insulated material in observance of potentially-present damaging surface voltages.
The DS200GSIAG1CDC Board Operational requirements include an ambient temperature of 0 to 45 degrees Celsius in non-condensing humidity levels between five to 95 percent. Boards should not be used above 2000 meters and should be protected from radio interference at 27 MHz, 150 MHz, and 480MHz.
GE Mark V boards meet UL 796 standard as well as ANSI IPC guidelines and ANSI IPC/EIA guidelines.
Additionally, the Mark V system meets UL 580A safety standards for industrial control equipment.
Refer to manuals, user guides, and other GE documentation for additional information.
Before making any ultimate purchase decision on this DS200GSIAG1CDC product offering, it is critical to realize that its originally-introduced performance specifications and dimensions have no doubt been altered from their original statuses as a function of this DS200GSIAG1CDC device's possession of two functional product revisions and an artwork configuration revision; rated at grades of C, D, and C, respectively.