DS200DMCAG1AGB

About the DS200DMCAG1AGB

The DS200DMCAG1AGB is an Interface board within its greater Mark V product series. It is a large rectangular board with factory-made drill holes located along the board’s edges including in each corner of the board, as well as in the board’s center. This DS200DMCAG1AGB Gen/Log/Key Interface Board is marked for alignment on two edges, and carries the GE logo and several identifying codes. This DS200DMCAG1AGB Mark V Series unit has one female and four male vertical cable connectors, as well as several vertical pin header connectors. Additionally; there are several stab-on connectors located near a cluster of high-voltage electrolytic capacitors in the upper left corner of the board. Additional components on the surface of the DS200DMCAG1AGB include:

• jumper switches
• fifteen resistor network arrays
• a toggle switch marked “reset”  
• four LED units with four, three, or two lights per unit
• one inductor coil
• two heat sinks with mounted components

There is an auxiliary board mounted to the DS200DMCAG1AGB’s surface that is populated with several integrated circuits, and an additional fifty integrated circuits on the board’s primary surface. It is a bit of a surprise that this DS200DMCAG1AGB Gen/Log/Key Interface Board does not possess any sort of Mark V Turbine Control System Series special assembly, as similar Mark V Series products that feature auxiliary boards tend to at least achieve a Mark V Series motherboard assembly status.

In terms of various standard voltage-limiting hardware components, the DS200DMCAG1AGB uses diodes, ceramic and polyester vinyl capacitors, and metal film resistors, and all of the aforementioned hardware selections receive protection from the DS200DMCAG1AGB PCB's standard normal style of printed circuit board protective coating.