The DS3800HRTA1A1A is part of the Mark IV (Speedtronic) series created by General Electric (GE). There are about sixteen groups of Jumper ports. The Jumper Ports come with a plastic cover, that could be positioned on the groups of Jumper Ports or not utilized at all. These covers allow the operator to adjust how the energy current moves around the circuit board. The DS3800HRTA1A1A has a variety of diodes which only allow energy to move one way through them. There are two pastel blue diodes, two blue-green diodes, thirteen see-through diodes, and eight black diodes. There are four LEDs. The LEDs will illuminate red when an electrical current flows past them. The DS3800HRTA1A1A has about twenty resistors. Every resistor has distinct colored marks to notate its energy capacity. The DS3800HRTA1A1A has four points (one in each corner) to fasten the DS3800HRTA1A1A in place. The DS3800HRTA1A1A has a feminine port and two masculine ports. These ports facilitate the DS3800HRTA1A1A to be associated with other circuit boards in the system. The DS3800HRTA1A1A two beige capacitors and has five dark capacitors. The DS3800HRTA1A1A are thirty-six integrated circuits. Integrated circuits are also referred to as EPROM and EEPROMs, which hold the all the information for the DS3800HRTA1A1A. The EEPROMs come programmed. The EPROMs use a slight ring-shaped spot on the horizontal exterior of the device to be updated (these ring-shaped spots are also an easy way to identify the EEPROM and EPROMs). The DS3800HRTA1A1A has a single grey square, called a crystal oscillator, these are employed to create a very precise frequency.
AX Control’s educated staff would be pleased to provide you with a quote.