The GE Circuit Board DS3800DFPH1B1A features 1 34-pin ribbon cable and 3 trimmer potentiometers. The GE Circuit Board DS3800DFPH1B1A also is populated with multiple test points and 1 transistor-transistor logic component embedded on the board. The drive is mounted on the wall of the site and so the selection of an appropriate location must take many factors into consideration. The drive is mounted on the wall using a template for the location of mounting bolts. Use proper hardware for the mounting of the drive because it is heavy and requires sturdy installation hardware. The location must be cool and proper space must be planned for so that the drive has several inches around it for air to flow between all devices.
If devices are crowded on the wall, heat can easily build up and cause the devices to overheat. It is important to inspect the room on the other side of the wall on which you are installing the drive. If it is hot due to drives and other equipment in the room, you might have to cool the room before you install the drive. This can be accomplished in several ways. The installation of fans can force the air to move over the equipment and prevent the heat from building up. Another solution is to install vent hoods that draw heat from the equipment. The air is removed by means of fans that draw the hot air into the hood and it is exhausted from the room.