The Eurotherm 620L00404000010UKENW0000000B0000000 enables speed control of induction motors with an encoder. It also provides for a co-processor and ports for a fibre optic communications network.
The installation of the Eurotherm 620L00404000010UKENW0000000B0000000 must meet all local and national standards for electrical, mechanical, and manufacturing codes. However, there are best practices that you should consider when you plan the installation.
Power supply cables should exceed the rating for the expected supply current. For example, it is best practice to use cable that are rated as 110% of expected supply current.
Power cables are generally considered to be noisy, that is, they contribute to interference that disrupts other devices. This is especially true of 3-phase motor cables. When you plan the cable routing, keep all power cables away from cables that carry setpoints or feedback signals. Also keep the power cables from other electronic equipment and the cables connected to them.
Attach a filter to the power supply cables to avoid causing interference. Also, consider that the power supply must be 3-phase and within the specified voltage range for the 620L00404000010UKENW0000000B0000000.
Sometimes it is necessary to run a noisy cable and a sensitive cable in parallel. Keep at least 0.25 meters between the cables to minimize interference. Also, if the cables must be run in parallel for a long distance, increase the separation between the two cables. It is best practice to not run the noisy and sensitive cables in parallel. Instead, rout them to cross each other at a right angle.