To install the In-Sight IS511000 Vision System, you must install the lens, connect the Ethernet cable, connect the breakout cable, install the In-Sight Explorer software on a networked laptop, or other device, and log on to the Vision System.
The IS511000 contains 128MB non-volatile flash memory and unlimited storage through a remote network device. The image processing memory is 256 MB. The resolution is 640x480. The sensor type is ⅓-inch CCD. The weight is 350 g (12.3 oz.) with the lens cover installed and without the lens. The IS511000 is surrounded in a die-cast aluminum housing.
The image bit depth of the In-Sight IS511000 Vision System is 256 grey levels (8 bits/pixel) at 60 full frames per second.
The operating temperature of the IS511000 is 0°C to 45°C (32°F to 113°F). The operating humidity is 95%, non-condensing (operating and storage). The Ingress Protection rating is IP67 (with appropriate lens cover installed). The vibration rating (shipping and storage) is 10 G from 10-500 Hz with 150 gram lens per IEC 68-2-6. The shock rating (shipping and storage) is 80 G shock with 150 gram lens attached per IEC 68-2-27.
The minimum firmware requirement for the IS511000 is In-Sight version 4.4.3.
With the lens installed, the dimensions are 83.4mm (3.28in) x 124.2mm (4.89in) x 61.4mm (2.42in). Without the lens cover installed, the dimensions are 43.5mm (1.71in) x 124.2mm (4.85in) x 61.4mm (2.42in) including the thread guard. Before you install the IS5100C, consider that the device power consumption is 24VDC ±10%, 500mA maximum.
AX Control Inc. sells new surplus and reconditioned products. This website is not sanctioned or approved by any manufacturer or tradename listed.
AX Control Inc. is not an authorized distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands appearing
herein are the property of their respective owners.
Copyright 2020 - AX Control Inc. - All Rights Reserved