The Automation Direct Facts Engineering Koyo F0-04DAH-1 is an analog output module. A four channel module, this unit is compatible with DirectLogic 05 and 06 programmable logic controllers. A wide array of modules were manufactured to allow the PLC to function in any capacity needed. This module allows for analog outputs to be transmitted from the PLC to an analog device. Each channel is updated with new data following every scan of the controller’s internal CPU. Simple installation and removal are paramount design features of the module. The terminal block is easily removed without having to rewire the controller.
High quality data conversions are supported by the full 16-bit resolution the module offers. For F0-04DAH-1 to run, certain software requirements must be met by the PLC. If running the module on a DL05 PLC, DirectSOFT32 Version 3.0c or later and firmware version 5.20 or later are needed to run the unit. DL06 series controllers require DirectSOFT32 Version 4.0 Build 16 or later and firmware version 2.30 or later.
Temperature sensitivities of the module require proper storage and installation parameters to be met to ensure the device’s integrity. When in storage, temperatures can safely range from -20℃ up to 70℃, or -4℉ to 158℉. Once installed into a controller, the ambient temperature of the facility should fall no lower than 0℃, or 32℉, and should raise no higher than 55℃, or 131℉. Automation Direct offered technical support originally on the module. Be sure to refer to the part excerpt in the manual as well as the device’s datasheet for all technical and installation guidelines.
AX Control is happy to assist you with all of your F0-04DAH-1 needs. Pricing for repairs or replacement modules can be obtained by calling or emailing our office.
AX Control Inc. sells new surplus and reconditioned products. This website is not sanctioned or approved by any manufacturer or tradename listed.
AX Control Inc. is not an authorized distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands appearing
herein are the property of their respective owners.
Copyright 2018 - AX Control Inc. - All Rights Reserved